DAA Output Chute and Spring
DAA Output Chute and Spring
DAA Output Chute and Spring
DAA Output Chute and Spring

DAA Output Chute and Spring

DAA-103104
Out-of-Stock
€23.95
Tax included


 

The DAA Output Chute can be attached to any reloading press, hanging onto the same bracket which usually holds the Akro-Bin, and replacing it.

The long, 120cm (4ft) feed spring enables you to run the ammo down to a container on the floor, sparing you the need to empty that bin as you reload, and uncluttering your reloading press.

This Output Chute is also designed to clip on below the output ramp of the DAA Automatic Brass Marker, and can be used there to output the ammo down to a container on the floor or below your workbench.

This Chute has been tested to work perfectly with all pistol caliber ammo (9-40), although some types of 0.45 bullets have been seen to hang up occasionally. It works well with .223 rifle ammo too. It is designed to handled loaded ammo, not brass, which is more likely to hang-up.

New

Customers who bought this product also bought:

Customers who bought this product also bought:

24 other products in the same category:

Viewed products

Product added to compare.
Product added to wishlist